Water Supply Connection; Filling Auxiliary Water Tank; High Pressure Hoses - Prochem BLAZER PLUS Operating Instructions Manual

Operate this unit and equipment only in a well-
ventilated area. Exhaust fumes contain carbon
monoxide which is an odorless and deadly
poison that can cause severe injury or fatality.
DO NOT operate this unit where the exhaust may
enter any building doorway, window, vent, or
opening of any type.
CHECK FOR ADEQUATE FUEL
Check the fuel tank to be certain there is adequate
fuel to complete the job. This unit uses
approximately 1.0 gallons of fuel per hour at the full
RPM cleaning speed.
REMOVE TOOLS FROM VEHICLE
Remove any tools or hoses from the van which you
will require.

WATER SUPPLY CONNECTION

NOTE: Before connecting your water hose to the
supply faucet, flush out the faucet until the water
is free of any debris. Flush out any debris which
may be in your water inlet hose.
1. Connect the water supply hose to the water
inlet quick-connect at the front of the unit.
Connect the hose to the water supply faucet.
NOTE: Never use your waste pump outlet hose
as a water inlet hose. Use only clean hoses for
water inlet.
2. Turn the water supply faucet on. The water
will fill the water box.

FILLING AUXILIARY WATER TANK

Your cleaning unit may be equipped with an auxiliary
water tank mounted underneath the console. To fill
the auxiliary water tank:
1. Attach supply hose (part #10-805295) to supply
faucet.
2. Connect supply hose to auxiliary tank quick
connect on the right side of tank.
3. Turn on water supply. Fill tank.
4. Turn supply faucet off and remove supply hose.
HIGH PRESSURE HOSE
Before starting the unit, connect the pressure hose
to the outlet connection at the front of the unit.
Connect the cleaning tool to the pressure hose .
BLAZER 980073 09/16/02
OPERATION
3-11