Table of Contents
Advertisement
Installation
• Remove the 2 or 4 transportation screws (A) on the back and remove
the 2 or 4 flat washers, rubber bungs and plastic spacer tubes (B) as
illustrated in figure 1.
• If the washing machine is built-in, unscrew the 3 or 4 transportation
screws (A) and remove the 3 or 4 flat washers, rubber bungs and
plastic spacer tubes (B).
Fig 1.
• During the removal of the screws occasionally spacer tubes fall inside
the product, these can be removed by tilting the product forward and
recovering them from the floor or inside the base of the machine.
• Cover the open transportation screw holes with the 2 or 4 plastic caps
included in the instruction bag.
• Warning: keep packaging materials away from children.
• Place the corrugated plastic sheet, found on top of the appliance
during the unpacking process, into the base of the appliance as shown
in figure 2 (according to the model, consider version A, B or C).
• In some models this operation will not be necessary, because the
corrugated plastic sheet will be already placed on the bottom of the
appliance.
Fig 2.
9
Advertisement
Table of Contents
