Table of Contents
Advertisement
Trouble shooting
Fault
Unsatisfactory washing
results.
Laundry has detergent
residue.
Grey spots appear on the
laundry.
As soon as the machine is
loaded with water, water
discharges.
The spin cycle does not
take place or takes place
later than expected.
Possible cause
The dirtiness of the laundry
does not match the
programme select.
Insufficient amount of
detergent used.
The washing machine is
overloaded with laundry.
Hard water.
Your laundry is too tightly
packed together in the drum.
Non-dissolving particles of
some detergents may appear
on your laundry as white spots.
There is untreated oil, cream or
ointment on your laundry.
The end of water drain hose is
too low for the machine.
No fault. The unbalanced load
control system has been
activated.
50
Removing methods
Select the appropriate
programme for the dirtiness
of the laundry.
Adjust the amount of
detergent based on the dirt
level of the laundry.
Load the washing machine
with the correct amount and
weight and do not exceed
maximum laundry capacity.
Increase the amount of
detergent following the
manufacturer's instructions.
Check that your laundry is
spread out.
Perform an extra rinse, or
clean your laundry with a
brush after it dries.
Use the amount of detergent
as instructed on the
packaging in the next wash.
Check that the drain hose is
at a suitable height.
The unbalanced load control
system will try to spread your
laundry. The spinning cycle
will begin once your laundry
is spread. Load the drum
evenly for the next wash.
Advertisement
Table of Contents
