4k uhd hdbaset receiver with bidirectional ir, rs-232 and poh (4k: 35m/115ft, 1080p: 70m/230ft) (4 pages)
Summary of Contents for Wyrestorm RX-70-POH
Page 1
RX-70-POH WyreStorm HDBaseT™ POH Display Receiver with Bi-directional IR Control and RS-232 (1080p: 70m/230ft, 4K: 35m/114ft) Instruction Manual Thank you for choosing this WyreStorm product. Please read these instructions carefully before installing to avoid complications later. US/CAN/MEX: +1-518-289-1294 Toll Free Technical Support: +1-844-280-WYRE (9973)
Contents Safety Precautions Contents Introduction Features In the Box Panel Description Applications RJ45 Termination and Cat5e/6 Cable Distance Initial Connection IR/RS-232 Control Connection Update RS-232 Settings RS-232 Connection Troubleshooting Maintenance Provided Service Mail In Service Warranty Warranty Limits and Exclusions Disclaimer Installation Notes US/CAN/MEX: +1-518-289-1294...
Introduction The RX-70-POH Display Receiver utilizes powerful Class B HDBaseT technology to receive transmissions of uncompressed full 1080p HD video@60Hz/36bit up to 70m/230ft and 4K up to 35m/114ft, including HD multichannel audio, Bi-directional IR control, RS-232 and remote power from compatible transmission devices, such as WyreStorm matrices, transmitters or presentation switchers using a single shielded* or unshielded Cat5e/6 cable - all within a low- wyrestorm.com...
In the Box 1x IR emitter Video and Audio Transmission Distance ESD Protection US/CAN/MEX: +1-518-289-1294 Toll Free Technical Support: +1-844-280-WYRE (9973)
Receiver Mode Normal: Flashing: Update: NOTE: if used with a transmission device that does not HDCP LED support serial control of the receiver, the RS-232 port can Flashing: 2 3 4 5 Technical support: support@wyrestorm.com EMEA/ROW: +44 (0) 1793 230 343...
IR receiving area to enable control of the display from a source location. NOTE: Transmission device must be PoH-enabled to remotely power the RX-POH-70. RS-232 HDMI OUT Connects to display device Applications WyreStorm HDBaseT PoH Matrix as Transmission Device IR Emitter HDMI HDMI IR Emitter HDMI IR Receiver HDBaseT Transmission Device...
– take care to avoid where possible. WyreStorm recommends using supplied mounting brackets to secure the receiver to a flat surface behind/near the display device. Sudden movement of these devices could lead to loss of picture/sound if connections become loose or strained, resulting in unnecessary service call-backs.
NOTE: For serial control via the RS-232 port on the RX-70-POH please ensure the MODE switch is set to Normal. The Update setting is reserved for firmware updates. Serial control at display end requires a compatible model WyreStorm matrix featuring compatible HDBaseT transmission device with routable RS-232.
9) Cable wired to 568B standard? 10) Electrical interference 11) Is a picture achieved when connecting the source directly to the display? 12) HDMI lead condition and quality Technical support: support@wyrestorm.com EMEA/ROW: +44 (0) 1793 230 343...
Page 11
13) Picture speckles/HD ‘noise HD Noise (NO image) 14) Blu-ray: 3D 15) 4K 4K resolution - section for more details 1080p 16) Color distortion No Sound or Poor Quality Audio 1) Have specific speaker sets or zones been enabled? NOTE: If problems are experienced when an AV receiver is used, the cause is usually the settings of the AVR itself. Refer to the AVR manufacturer’s guidelines on the correct settings to use for your requirements.
The remote transmitter can be seen flashing to indicate a signal being sent. Replace batteries if flashing is not seen on the digital camera screen. • Plasma screens Cat5e or 6? Can I use a single Cat 5e/Cat 6 cable? How far can the signal travel? Technical support: support@wyrestorm.com EMEA/ROW: +44 (0) 1793 230 343...
Page 13
What about 3D? How do I control the sources? Do I need power at the TV end? Are WyreStorm products compatible with HDMI 1.4? What about screens with different resolution capabilities? wyrestorm.com for more details How does the Transmission device handle HDCP?
Disclaimer WYRESTORM PUBLICATION DISCLAIMER WYRESTORM IS NOT RESPONSIBLE FOR MALFUNCTIONS AND/OR THE IN-OPERABILITY WHICH MAY BE CAUSED BY THE APPLICATION OF THIS INFORMATION, WHETHER EXPECTED OR NOT. Installation Notes...
Page 16
Tel: +1 518-289-1293 WyreStorm Technical Support Email: Visit wyrestorm.com for the latest information on products.. 150911 Technical support: support@wyrestorm.com EMEA/ROW: +44 (0) 1793 230 343...
Page 17
UTP OUT of the transmission device (matrix or transmitter) to with Cat5e, we recommend Cat6 as standard due Cat6 the HDBT IN or UTP IN Input of the RX-70-POH. If the transmission to increased bandwidth and improved capacity for 4K - 35m/114ft handling large transmissions along a single cable.
Page 18
Visit wyrestorm.com for full details on this product and to download the 4K - Are you trying to pass a 4K signal? Ensure connected devices mode and warranty information.
Page 19
HD multichannel audio and control transmissions using directly along Cat5e/6 up to 35m/114ft (4K) or 70m/230ft single Cat5e/6 (1080p) from compatible transmission device to RX-70-POH for • Support 35m/114ft 4K transmission distances up to no local power required at display locations 4096x2160@30Hz 4:4:4 and 4096x2160@60Hz 4:2:0 •...
Page 20
IR Emitter HDBaseT Cat5e/6/6a HDMI HDMI IR Emitter HDMI IR Receiver HDBaseT Cat6 HDBaseT Transmission Device (WyreStorm MX-0808-PP-POH shown) IR / RS-232 IR to Control System RS-232 CAB-IR-LINK (Sold Separately) RS-232 North America: 1 844-280-WYRE (9973) EMEA/ROW: +44 (0) 1793 230 343...
Need help?
Do you have a question about the RX-70-POH and is the answer not in the manual?
Questions and answers