B.3 Parameters In The Security Menu - PRIMERGY TX200 S3 Configuration Manual

Hide thumbs Also See for TX200 S3:
Table of Contents

Advertisement

B Configuration Sheets of BIOS Setup Utility Parameters
■IPMI Submenu
( ) The initial values have been unchanged.
Item
IPMI
SEL Load
Clear System Event Log:
Event Log Full Mode:
iRMC Time Sync:
> System Event Log
> SDRR Browser
> LAN Settings
■LAN Settings Submenu
( ) The initial values have been unchanged.
Item
LAN Settings
DHCP:
Local IP address
Subnet mask
Gateway address
B.3 Parameters in the Security menu
( ) The initial values have been unchanged.
Item
Setup Password
System Password
Set Setup Password:
Setup Password Lock:
Set System Password:
System Password Mode:
System Load:
Setup Prompt:
Virus Warning:
Diskette Write:
Flash Write:
*1:Can be set when [Setup Password] is set.
*2:Can be set when [System Password] is set.
Initial value
xx%
Displays percentage of stored SEL
Disabled
( )Enabled
Overwrite
( )Maintain
Enabled
( )Disabled
Displays System Event Log
Displays information of sensors
Links to LAN Settings submenu
Initial value
Disabled
( )Enabled
[000.000.000.001]
IP address of iRMC
[
[000.000.000.000]
Subnet mask
[
[000.000.000.000]
Gateway address
[
Initial value
Not installed
Displays whether or not the setup
password is set.
Not installed
Displays whether or not the system
password is set.
Press Enter
Enter the setup password.
Standard
( )Extended
Press Enter
Enter the system password *1
System
( )Keyboard *2
Standard
( )Diskette/CDROM Lock
Enabled
( )Disabled
Disabled
( )Enabled ( )Confirm
Enabled
( )Disabled
Enabled
( )Disabled
12
Setting
Setting
.
.
.
]
.
.
.
]
.
.
.
]
Setting

Advertisement

Table of Contents
loading

Table of Contents