Advertisement
4. Set the engine ON/OFF switch to "ON".
5. Pull the starter rope handle slowly until you feel
resistance.
6. Release the starter rope handle to let the starter
rope go back.
7. Pull the starter rope handle until the engine starts.
8. Open the choke control gradually until it is fully open.
9. Let the engine operate at idle speed for 2–3 minutes.
10. Set the throttle control to full throttle.
1096 - 003 - 06.04.2020
To stop the product
1. Move the throttle control to the idle speed position.
2. Set the ON/OFF switch to "OFF". The engine stops.
3. Move the fuel valve to the "OFF" position.
To do if the engine does not start
If the engine does not start and white smoke shows, do
the procedure that follows.
1. Set the throttle control to the stop position.
2. Slowly pull and release the starter rope handle 5
times.
3. Do the start procedure again.
To operate the product
CAUTION: Always operate the product
forward and at full throttle. Lower engine
speed and rearward movement prevent
correct function of the eccentric element and
can cause product failure.
1. Make sure that the throttle control is set to full
throttle.
2. Carefully push the product forward.
CAUTION: Do not push the product
down. Too much pressure can cause
unsatisfactory result.
3. To change direction, turn the product around.
9
Hide quick links:
Advertisement
