Husqvarna LX 90 Operator's Manual page 13

• Attach the lifting equipment at the lifting point of the
safety frame. A label on the product identifies the
correct position.
A
B
WARNING: Do not use metal hooks,
chains or other lifting equipment with
rough edges that can cause damage to
the lifting eye.
WARNING: Do not lift a damaged
product. Make sure that the safety frame
(A) and the vibration damping units (B)
are correctly installed and not damaged.
To safety the product to a transportation
vehicle with tie-down straps
• Put 2 straps (A) around the bottom plate.
1096 - 003 - 06.04.2020
Storage
•
•
•
•
•
•
•
Disposal
•
•
•
A
a) Put 1 strap around the front of the bottom plate
and attach the strap to the vehicle.
b) Put 1 strap around the rear of the bottom plate
and attach the strap to the vehicle.
Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
Clean the product before storage. Remove oil and
dust from the rubber parts.
Clean the air filter before storage.
Carefully pull the starter rope handle until there is a
small resistance. This closes the valves and makes
sure that moisture cannot go into the engine
cylinder.
Put a protective cover on the product.
Keep the product in a dry and frost free area.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Obey the local recycling requirements and applicable
regulations.
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
13