Table of Contents
Advertisement
IP protection class for your product. The use under ambient conditions different from those specified in this
manual may result in damage of the product.
·
Do not subject this product to direct sunlight, moisture or shock.
·
Lay cables in such way that no one can step on or they do not represent a trip hazard.
·
Before starting up, check if the electrical wiring corresponds to the specifications in this manual. Faulty
wiring (overvoltage, undervoltage) can result in a damage in the electronics.
3.3 Operation and power supply
WARNING! Non-approved power supplies for product operation may cause painful or dangerous electric shock.
Serious injury or death may occur. Use a power supply that meet the safety extra-low voltage (SELV) and
limited power source (LPS) requirements.
·
In order to ensure electrical safety, we recommend using a shielded network cable or connecting the housing
to ground so that the housing is connected via the proper installation to ground.
CAUTION! Class 1 laser
The accessible laser radiation is harmless under reasonably predictable conditions. Observe the legal
regulations for laser protection.
NOTICE! The housing may get hot depending on the operating conditions. Provide sufficient heat dissipation.
3.4 Transport
·
To avoid any damage to the connectors, only mount or remove the product with the cables disconnected.
·
Keep packing materials like films away from children. In case of abuse there is a risk of suffocation.
3.5 Correct disposal
To prevent possible harm to the environment, separate the product and accessory items from other types of
waste. Dispose professionally the product and accessory items to encourage the recycling of reusable
material.
According to the EC Directive 2012/19/EU (WEEE) we are obliged to take back this product, distributed by us
after August 13, 2005, free of charge at the end of its useful life and to ensure it correct disposal. As this
product is exclusively for commercial use (B2B), it must not be handed over to a public disposal facility. The
product can be disposed of by specifying the date of purchase and the serial number at the following address:
IDS Imaging Development Systems GmbH
Dimbacher Str. 6-8
D-74182 Obersulm
September 2018
Setup: IDS NXT vegas
5
Advertisement
Table of Contents
