Please contact your local IDS distributors for first level support in your language. For a list of IDS distributors worldwide please go to our website http://www.ids-nxt.com.
All warranty will be spoiled in this case. Intended use IDS industrial cameras are to be used to capture images for visualization and image processing tasks. They are designed for use in industrial environments. Please comply with the requirements for the proper use of this product.
Page 5
IDS NXT vegas: Hardware description Operation and power supply The camera power supply must meet the requirements for SELV (safety extra low voltage)/LPS (limited power source) or ES1/PS2. WARNING! Non-approved power supplies for camera operation may cause painful or dangerous electric shock.
3 IDS NXT vegas 3.1 Standards and directives (only valid for devices with housing) IDS Imaging Development Systems GmbH hereby confirms that this product has been developed, designed and manufactured in compliance with the following European directives · 2014/30/EU: EMC - Electromagnetic compatibility ·...
With increasing device temperatures, the image quality could be reduced due to thermal noise. It is recommended to mount the IDS NXT vision app-based sensor to a heat-dissipating unit even if the device is operated below the maximum specified temperature.
IDS NXT vegas: Hardware description 4 Mechanical data Dimensions height x width x depth 90 mm x 52.5 mm x 43.1 mm Weight 185 g · Material Front: Plastic ABS · Back: Aluminum Protection class IP65 · Mounting T-slot nuts in the back, M4 ·...
· Network mode · IP address of the device · MAC address of the device 7.2 Status LEDs The IDS NXT vegas has 2 LEDs (two-color: red and green) for status indication of the power supply and the network. 2020-01-21...
Device obtains IP address via DHCP 7.3 Acknowledgement LED CAUTION! Optical radiation from visible LED light. Do not look into beam! The IDS NXT vegas has an acknowledgement LED, which gives optical feedback when image processing is successful. · 1x LED ·...
Acknowledgement LED 7.4 Integrated lighting CAUTION! Optical radiation from visible LED light. Do not look into beam! The IDS NXT vegas has an integrated LED lighting besitzt eine integrierte LED-Beleuchtung, which can be additionally activated. Monochrome version rev. 1.2 Color version rev. 1.2...
120 mVpp 120 mVpp IDS Imaging Development Systems GmbH recommends to adjust the power supply to the power requirement of the camera to limit overheating in case of short circuit. To ensure electrical safety, the power supply must meet the requirements for SELV (safety extra low voltage)/LPS (limited power source) or ES1/PS2.
IDS NXT vegas: Hardware description Schematic drawing Trigger input wiring/OPTO IN Pin 5 is the reference level (GND) for all inputs. All three inputs can also be used with different voltages. 10.4 Flash output wiring/OPTO OUT Symbol Minimum Typical Maximum...
Only one output can be connected as an open emitter, since the load is on pin 6. The other outputs cannot be used anymore. 10.5 RS-232 wiring The IDS NXT vegas has a serial interface of the type RS-232: · Baud rate: 300 … 230 400 Baud...
Page 20
IDS NXT vegas: Hardware description · Input voltage: max. ±15 V · Output voltage: -5,7 V to +6.2 V · Data rate: max. 250 kbps · Compatible with TIA/EIA-232-F standard · Permissible range according to RS-232 from ±3 V to ±15 V The data rate of the serial interface depends on the capacity and length of the cable.
IDS NXT vegas: Hardware description 11 Setup The setup of theIDS NXT vision app-based sensor is described in the separate manual "IDS NXT vegas: Setup". 2020-01-21...
IDS NXT vegas: Hardware description 12 Maintenance Over time, dust, abrasion, etc. may accumulate on the front glass, resulting in poorer image quality. Check the front glass in regular intervals depending on your operating conditions. Cleaning the front glass 1. If possible, turn off the device for cleaning to avoid glare by the LEDs (see...
IDS NXT vegas: Hardware description - A - - N - Ambient conditions Network note information - B - - O - Beeper Operating system OPTO IN - C - OPTO OUT Output Cleaning - R - Connector REACh network...