HP XW9400 Hardware Setup Manual page 20

7 Optional: Press F8 to select a language.
8 Select File | Flash
The Select a Drive dialog box appears.
9 Select CD-ROM, and press F10 to confirm.
10 Select the .bin file.
The Flash System ROM confirmation dialog box appears.
11 Press F10 to confirm.
12 Press any key.
A message stating that the system ROM flash was successful appears.
13 Verify system BIOS settings. See
page 12.
14 Select File | Save Changes and Exit.
Checking Your System BIOS Settings
You do not normally need to adjust these settings. BIOS settings for the
workstation are provided here for informational purposes only.
To enter the system BIOS, you must press F10 while booting the workstation.
The following table lists the proper Autodesk certified BIOS settings. Items
not listed are set to their default factory settings.
BIOS Menu
Storage
Advanced
12 | Chapter 2 Getting Started
®
System ROM.
Checking Your System BIOS Settings
Item
Boot Order
Boot Order, Hard Drive
OS Power Management, ACPI S3
Support
Chipset / Memory, ECC Support
Chipset / Memory, Memory
Scrubbing
Value
Optical Drive
USB Device
Integrated SATA
Integrated IDE
Disabled
Enabled
Enable
on