HP XW9400 Hardware Setup Manual page 19

version on your system does not correspond to the table below, you must
update to the certified version.
Visual Effects and Finishing
Application Version
2009
Updating Your System BIOS
The BIOS version installed on your system appears on the screen while booting
the workstation. The following procedure describes how to update a
workstation to the certified BIOS version required by your Autodesk Visual
Effects and Finishing application.
To update the BIOS on your workstation:
1 Open a terminal, and log is as root.
2 Insert the application DVD in the drive of the workstation and mount
it.
3 Go to the DKU_<
where
<version_number>
example:
cd /mnt/cdrom/DKU_3.0.0/Utils/BIOS
TIP If the DKU has already been installed on the workstation, you can access
its contents in the /usr/discreet/DKU directory, without having to use the
application DVD.
Each platform supported by the version of your Visual Effects and
Finishing application has its own directory that contains an .iso file.
NOTE For more information about updating the BIOS on your workstation,
refer to the README file also located in the platform's directory.
4 Type:
cd <platform>
5 Burn the .iso file onto a CD and place it in the DVD-ROM drive of the
workstation.
6 Reboot the workstation and press F10 to enter BIOS.
Certified BIOS Version
3.05
version_number
represents the version of the DKU. For
>/Utils/BIOS directory on the DVD,
System BIOS | 11