Chapter 1 Introduction; About This Guide - HP XW9400 Hardware Setup Manual

Introduction
Topics in this chapter:

About This Guide

Related Documentation
Notation Conventions
Contacting Customer Support
About This Guide
This guide describes how to set up the HP
Autodesk
Autodesk Flame
Conform).
If you already own an HP xw9400 workstation that shipped with a previous
release of a Visual Effects and Finishing application, you normally do not need
to change its configuration. But you do need to verify its BIOS and firmware
settings. See
Use this guide in conjunction with the Software Installation Guide, the
Configuration File Reference Guide, the Stone Direct Configuration Guide, and the
Stone and Wire Filesystem and Networking Guide to install and configure the
hardware and software components of your Visual Effects and Finishing system.
on page 1
on page 2
on page 2
on page 3
®
Visual Effects and Finishing 2009 application (Autodesk Inferno
®
, Autodesk Flint
BIOS and Firmware
®
xw9400 workstation for your
®
, Autodesk Smoke
on page 10.
1
®
, Autodesk Backdraft
®
,
®
1