Page 1
UltimusPlus Dispenser Network Connection Instructions Introduction This document provides procedures for connecting the UltimusPlus fluid dispenser to a network and then sending ™ commands to the dispenser, including commands to remotely switch dispense programs. Connecting the Dispenser to a Computer Switch ON the dispenser power.
Page 2
Select “Local Area Connection” (Windows 7) or “Ethernet” (Windows 10). Windows 7 Windows 10 Double-click (Windows 7) or right-click (Windows 10) to select “Properties.” Windows 7 Windows 10 www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
Page 3
Click OK in the Local Area Connection properties window (Windows 7) or the Ethernet properties window (Windows 10). Continue to “Communicating with the Dispenser” on page 4 to set up the computer to send commands to the dispenser. www.nordsonefd.com info@nordsonefd.com 800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.
Page 4
UltimusPlus Dispenser Network Connection Communicating with the Dispenser Once the computer is connected to the UltimusPlus dispenser, open a command prompt (or a terminal) and ping the IP address of the UltimusPlus dispenser. The default IP address of the dispenser is 192.168.10.40.