Nordson Ultimus IV Quick Start Manual

Ultimus ™ IV Dispensing System
Quick Start Guide
Electronic pdf files of Nordson EFD manuals are also available at
www.nordsonefd.com
Easy 11-Step Setup
Follow these steps to get your Ultimus IV ready for operation.
Unpack the Unit/Warranty
1
• Unpack the unit.
• Now is a good time to activate your Two Year Warranty. Register the
Install Barrel Holder & Cable Guide
2
Part A: Install Barrel Holder
• Install mounting blocks using two screws each.
• Remove barrel holder sleeve from holder. ∑
• Insert the 6 mm screw through the barrel holder and bracket, and then
• Insert barrel holder sleeve.
Part B: Install Cable Guide
• Insert thumbscrew through both
• Position flex arm into
• Tighten thumbscrew to secure arm to cabinet.
• Snap flexible cable assembly into swivel bracket,
warranty online at www.nordsonefd.com/warranty/dispensers/two/
Blocks may be mounted in the forward or rear position on either side. ∂
into the top hole of the front mounting block. Tighten screw to secure. ∏
the cable guide mount and star washer,
and then into other mounting block. π
channel of cable guide mount. ∫
located at top of flex arm. ª
ª
∑
∏
∂
∫
π
1