Maintenance; Care And Cleaning; Cleaning Discharge Honeycomb - Hussmann microSC SHM-A Series Installation & Operation Manual

P/N 3104942_B
To reduce the risk of fire, electrical shock or
injury when cleaning this merchandiser:
• Unplug the merchandiser before cleaning;
• Keep all liquids away from electrical and
electronic components;
• Do not use any mechanical device or other
means to speed the defrost process, except
as recommended by the manufacturer.

CARE AND CLEANING

Long life and satisfactory performance of
any equipment is dependent upon the care it
receives. To ensure long life, proper sanitation
and minimum maintenance costs, these
merchandisers should be thoroughly cleaned,
all debris removed and the interiors washed
down, weekly.
Exterior Surfaces
The exterior surfaces must be cleaned with a
mild detergent and warm water to protect and
maintain their attractive finish. n
AbrAsive cleAnsers or scouring pAds
Interior Surfaces
The interior surfaces may be cleaned with most
domestic detergents, ammonia based cleaners
and sanitizing solutions with no harm to the
surface. Self contained models empty into a
limited capacity evaporation pan, which will
overflow if excess water is used in cleaning.
DO NOT Use:
Abrasive cleansers and scouring pads, as these
will mar the finish or coarse paper towels on
coated glass. DO NOT use ammonia-based
cleaners on acrylic parts.
Solvent, oil or acidic based cleaners on any
interior surfaces. Do not use high pressure
water hoses.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

MAINTENANCE

DO NOT flood merchandiser with water.
n
ever introduce wAter fAster thAn the
wAste outlet cAn remove it
models empty into an evaporation pan that will
overflow if too much water is introduced during
cleaning.
Do Use:
Remove the product and all loose debris to
avoid clogging the waste outlet. Store product
in a refrigerated area such as a cooler. Remove
only as much product as can be taken to the
cooler in a timely manner. Disconnect electrical
power before cleaning.
Thoroughly clean all surfaces with soap and
hot water. d
pressure hoses to wAsh the interior
t
hese will destroy the merchandisers
sealing causing leaks and poor performance
Take care to minimize direct contact between fan
motors and cleaning or rinse water.
ever use
.
Allow merchandisers to dry before resuming
operation. After cleaning is completed, turn on
power to the merchandiser.

CLEANING DISCHARGE HONEYCOMB

Discharge honeycombs should be cleaned
every six months. Dirty honeycombs will
cause merchandisers to perform poorly.
The honeycombs may be cleaned with a
vacuum cleaner.
o not use steAm or high wAter
Do NOT use HOT water on Cold glass Surfaces.
This can cause the glass to shatter and could
result in personal injury. Allow glass fronts, to
warm before applying hot water.
SHM-A Merchandisers
4-1
. Self contained
.
'
.