Power Trigger - Husqvarna T540i XP Workshop Manual

4. Remove the 9 screws.
5. Remove the left crankcase half.
6. Assemble in the opposite sequence.
CAUTION: Make sure that all parts are
installed correctly in the crankcase to
prevent damage to the cables.
5.4.4 To replace the guide bar bolt
1. Remove the drive sprocket cover. Refer to
remove and install the drive sprocket cover on page
8 .
2. Remove the guide bar and the saw chain.
3. Disassemble the crankcase. Refer to
disassemble and assemble the crankcase on page
10 .
4. Remove the chassis. Refer to
the chassis on page 17 .
5. Remove the guide bar bolt.
6. Put the new guide bar bolt through the hole in the
chassis.
7. Use a hammer and a mandrel to install the new
guide bar bolt.
1204 - 001 - 03.12.2019
To
To
To remove and install
8. Install the chassis. Refer to
the chassis on page 17 .
9. Assemble the crankcase. Refer to
and assemble the crankcase on page 10 .
10. Install the guide bar and the saw chain.
11. Install the drive sprocket cover. Refer to
and install the drive sprocket cover on page 8 .
5.4.5 To remove and install the front handle
1. Disassemble the crankcase. Refer to
disassemble and assemble the crankcase on page
10 .
2. Remove the 2 screws and the front handle.
3. Install in the opposite sequence.

5.5 Power trigger

5.5.1 To disassemble the power trigger
1. Disassemble the crankcase. Refer to
disassemble and assemble the crankcase on page
10 .
2. Make a note of how the inner parts of the top handle
are installed.
To remove and install
To disassemble
To remove
To
To
Repair instructions - 11