Power Trigger - Husqvarna 340i Workshop Manual

3. Remove the 9 screws.
4. Remove the left crankcase half.
5. Assemble in the opposite sequence.
CAUTION: Make sure that all parts are
installed correctly in the crankcase to
prevent damage to the cables.
5.4.4 To replace the guide bar bolt
1. Remove the drive sprocket cover. Refer to
remove and install a drive sprocket cover attached
with a bar knob on page 11 .
2. Remove the guide bar and the saw chain.
3. Disassemble the crankcase. Refer to
disassemble and assemble the crankcase on page
15 .
4. Remove the chain brake wheel. Refer to
and install the chain brake wheel on page 25 .
5. Remove the guide bar bolt and the plate.
6. Put the new guide bar bolt through the hole in the
crankcase.
7. Use a hammer and a mandrel to install the new
guide bar bolt.
8. Install the chain brake wheel. Refer to
and install the chain brake wheel on page 25 .
16 - Repair instructions
9. Assemble the crankcase. Refer to
and assemble the crankcase on page 15 .
10. Install the guide bar and the saw chain.
11. Install the drive sprocket cover. Refer to
and install a drive sprocket cover attached with a bar
knob on page 11 .

5.5 Power trigger

5.5.1 To disassemble the power trigger (digital user
interface)
1. Disassemble the crankcase. Refer to
disassemble and assemble the crankcase on page
15 .
2. Make a note of how the inner parts of the power
trigger handle are installed.
To
To
3. Remove the power trigger lockout.
To remove
4. Make sure that the power trigger lockout has no
defects. Replace the power trigger lockout if it has
defects.
To remove
To disassemble
To remove
To
1435 - 001 - 11.06.2020