User Interface - Husqvarna T540i XP Workshop Manual

6. Hold the battery connector in position and install the
2 screws.
7. Hold the motor in position and install the 3 screws.
8. Install the cable cover.
CAUTION: Make sure that the battery
connector cables are in the correct position.
16 - Repair instructions
9. Install the user interface. Refer to
install the user interface on page 16 .
10. Assemble the power trigger. Refer to
the power trigger on page 12 .
11. Assemble the crankcase. Refer to
and assemble the crankcase on page 10 .
CAUTION: Make sure that all cables and
parts are installed correctly before you
assemble the crankcase.
12. Install the worm gear. Refer to
the worm gear on page 8 .
13. Install the brake drum. Refer to
install the brake drum on page 8 .
14. Install the drive sprocket. Refer to
install the drive sprocket on page 8 .
15. Install the drive sprocket cover. Refer to
and install the drive sprocket cover on page 8 .

5.8 User interface

5.8.1 To remove and install the user interface
1. Disassemble the crankcase. Refer to
disassemble and assemble the crankcase on page
10 .
2. Disassemble the power trigger and the power trigger
To disassemble the power trigger
lockout. Refer to
on page 11 .
3. Disconnect the chain brake sensor.
To remove and
To assemble
To disassemble
To remove and install
To remove and
To remove and
To remove
To
1204 - 001 - 03.12.2019