Front Hand Guard; Motor And Control Unit - Husqvarna T540i XP Workshop Manual

Hide thumbs Also See for T540i XP:
Table of Contents

Advertisement

4. Make sure that the power trigger lockout has no
defects. Replace the power trigger lockout if it is
necessary.
5. Install the power trigger lockout.
Note: Make sure that the edges (A) of the power
trigger and the power trigger lockout are in the
correct positions.
A
To disassemble
6. Assemble the crankcase. Refer to
and assemble the crankcase on page 10 .

5.6 Front hand guard

5.6.1 To remove and install the front hand guard
To
1. Disassemble the crankcase. Refer to
disassemble and assemble the crankcase on page
10 .
2. Remove the screw.
3. Carefully turn the front hand guard to remove it from
the crankcase half.
4. Install in the opposite sequence.

5.7 Motor and control unit

5.7.1 To remove the motor, control unit and battery
connector
CAUTION: Do not pull the cables.
To
1. Remove the drive sprocket cover. Refer to
remove and install the drive sprocket cover on page
8 .
To remove and
2. Remove the drive sprocket. Refer to
install the drive sprocket on page 8 .
To remove and
3. Remove the brake drum. Refer to
install the brake drum on page 8 .
To remove and
4. Remove the worm gear. Refer to
install the worm gear on page 8 .
Repair instructions - 13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents