Extreme Networks ExtremeSwitching SLX 9540 Hardware Installation Manual page 52

Installing the Universal Four-Post Rack Kit (XEN-R000296)
1. Rear bracket, short or long
Attaching the rear brackets to the front rack posts
Complete the following steps to attach the rear brackets to the front rack posts.
1. Attach the right rear bracket to the right front rack post using two 10-32 x 5/8-in. screws and two retainer nuts, as shown in
Figure 30. Use the upper and lower holes in the bracket.
2. Attach the left rear bracket to the left front rack post using two 10-32 x 5/8-in. screws and two retainer nuts. Use the upper and
lower holes in the bracket.
3. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 30 Attaching the rear brackets to the front rack posts
1. Screws, 10-32 x 5/8-in., panhead Phillips
52
2. Screws, 6-32 x 1/4-in., panhead Phillips
2. Retainer nuts, 10-32
ExtremeSwitching SLX 9540 Hardware Installation Guide
9036360-00 Rev AB