Extreme Networks ExtremeSwitching SLX 9540 Hardware Installation Manual page 50

Installing the Universal Four-Post Rack Kit (XEN-R000296)
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 27 Positioning the device in the rack
1. Screws, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the extensions at the front of the device
Complete the following steps to attach the rear brackets to the extensions. There are short and long front brackets that you can use for
this step.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension.
The short rear brackets are shown in
Refer to Figure 29
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4. Repeat step 2 and step 3 to attach the left rear bracket to the left extension.
50
Figure 28. Use the first and third vertical pairs of holes for the screws.
for the positioning of the short or long brackets and screws.
2. Retainer nuts, 10-32
ExtremeSwitching SLX 9540 Hardware Installation Guide
9036360-00 Rev AB