Westin 21-2350 Installation Instructions

ITEM QUANITY
1 1
2 4
3 2
4 2
5 4
6 4
7 4
8 6
9 6
10 6
11 8
12 8
13 4
14 4
15 12
1. Mounting locations are inside of the vehicles rocker panels facing the chassis. Remove the factory applied black tape and rubber grommets from
mounting locations.
2. Insert supplied clip nuts to rectangular slots so the back of the nut faces the inside of the rocket panel.
3. Attach one single bolt plate to the driver front mounting location. Then attach one double bolt plate at the rear driver side mounting location.
(The bolt plates will be secured with the mounting brackets in the next step)
4. Loosely attach the front driver side mounting bracket as shown in the schematic below. (Front brackets can be identified by the extra number of
mounting slots) use the supplied 12MM hex nuts, lock washers, and flat washers to join the bolt plate to the mounting bracket. Use the supplied
8MM Hex bolts, lock washers, and flat washers to secure the mounting bracket into the clip nuts installed before.
5. Repeat for the driver side rear bracket.
6. Using the 1/2" bolts, flat washers, and lock washers; attach the side bar to the mounting brackets.
7. Tighten all remaining hardware.
8. Repeat steps 2-7 for the passenger side bar.
(It is recommended to periodically re-check and tighten all hardware.)

CARE INSTRUCTIONS

REGULAR WAXING IS RECOMMENDED. DO NOT USE ANY TYPE OF POLISH OR WAX THAT MAY CONTAIN ABRASIVES
•
STAINLESS STEEL PRODUCTS CAN BE CLEANED WITH MILD SOAP AND WATER. STAINLESS STEEL POLISH SHOULD BE USED TO POLISH
•
SMALL SCRATCHES.
GLOSS BLACK FINISHES SHOULD BE CLEANED WITH MILD SOAP AND WATER
•
INSTALLATION INSTRUCTIONS
4" OVAL PLATINUM STEP BARS
2004-2007 FORD F-150 SUPER CAB
P/N: 21-2350 / 21-2355
CONTENTS
SIDE BAR (DRIVER & PASSENGER SIDE)
MOUNTING BRACKET
DOUBLE BOLT PLATE
SINGLE BOLT PLATE
1/2" X 2" HEX HEAD BOLT
1/2" FLAT WASHER
1/2" LOCK WASHER
12MM FLAT WASHER
12MM LOCK WASHER
12MM HEX NUTS
8MM X 30MM HEX HEAD BOLT
8MM LOCK WASHER
8MM HEX NUT
8MM CLIP NUT
8MM FLAT WASHERS
TOOLS
1/2" SAE SOCKET + RATCHET
1/2" SAE WRENCH
12MM SOCKET + RATCHET
12MM WRENCH
8MM SOCKET + RATCHET
8MM WRENCH