Flashforge FINDER Quick Start Manual page 6

1. Filament cartridge is at the back of printer. Before taking out filament cartridge, please hold the
clip on the top and take filament cartridge out.
Please pay attention to
loading direction!
2. Take out filament, tear off vacuum packing and put it into filament cartridge. Put filament through
filament outlet as the picture shown on the top left.
Attention: filament unwinding direction should keep pace with the picture, or causing cannot
print properly.
3. Hold clip on the top of filament cartridge, put
filament catridge back to the printer, and put
filament through filament guide tube.
Filament Guide Tube
Filament Outlet
Press here
4. After filament goes through guide tube, press
spring presser on the left side of extruder, and
insert filament vertically into filament intake to
the bottom.
05
Filament intake