Specifications; Safety Information; Installation - Prince Castle Universal JIB Series Operation Manual

Product Holding Bin
Universal JIB Series
Model
DHB4SS-20UJB
DHB2PT-33UJB
DHB2SS-33UJB
DHB4PT-20UJB
DHB2SS-20UJB
DHB2SS-27UJB
Indicates information important to the proper operation of the unit.
Failure to observe may result in damage to the equipment and/or
severe bodily injury or death.
A. Remove the unit from the carton and inspect for signs of damage. If
there is damage to the unit:
•
notify the carrier within 24 hours of delivery
•
save carton and packaging materials for inspection purposes
•
contact your local dealer, or if purchased directly, the Prince Castle
Sales Department at 800-722-7853 or 1-630-462-8800 to arrange for a
replacement unit.
NOTE: When installing this unit, the ambient temperature at the mounting
site should not exceed 100°F.
B. Place the bin on a counter and seal the base to the counter with food-
approved sealant.
C. Plug the power cord into the bin and connect the plug into the proper
electrical outlet (15 amp, 120 Volt). All connections must be in
accordance with local electrical codes and any other applicable codes.
NOTE: The electrical receptacle should be a dedicated outlet. No other
equipment should be operating on the line (refrigerators, fryers, etc.).
D. Install the racks, pans and pan covers into the cavities.
E. Turn the power switch to ON. Allow 30 minutes for warm-up.n
Prince Castle reserves the right to change specifications and product design without notice. Such revisions do not entitle the buyer to
corresponding changes, improvements, additions or replacements for previously purchased equipment.
Printed in USA 07/13 © 2013

Specifications

Voltage
120
208 – 240
208 – 240
120
120
120

Safety Information

WARNING

Installation

Watts Hertz
1700 60
2500 50/60
2500 50/60
1700 60
60
1700
60
1700
Indicates information important to the operation of the unit. Failure to
observe may result in damage to the equipment.
2
CAUTION
542-525