Set Up Instruction; Power On And Turn On / Off; Join Into Lora Network; Function Key - netvox R718N1 User Manual

4.Set up Instruction

4.1 Power on and Turn on / off

(1) Power on and turn on: open the battery cover; insert two sections of 3.6V ER14505 AA
batteries; close the battery cover; the device is at off mode by default setting. Press and hold function
key for 3 seconds till the green indicator flashes and release to turn on.
(2) Turn off: Press and hold function key for 5 seconds till the green indicator flashes quickly and
release. The green indicator will flash 20 times to show that the device is turned off.
Note:
1. The interval between shutting down twice or power off/on is suggested to be about 10 seconds to
avoid the interference of capacitor inductance and other energy storage components.
2. Once the battery is removed, the device is at off mode by default setting.
4. Turn off operation is same with "Restore to Factory Setting" operation.

4.2 Join Into LoRa Network

To join the device into LoRa network to communicate with LoRa gateway.
The network operation is as following:
(1) If the device had never joined any network, turn on the device; it will search an available LoRa
network to join. The green indicator will stay on for 5 seconds to show it joins into the network,
otherwise, the green indicator does not work.
(2) If R718N1 had been joined into a LoRa network, remove and insert the batteries; it will repeat
step (1).

4.3 Function Key

(1) Press and hold function key for 5 seconds to reset to factory setting. After restoring to
factory setting successfully, the green indicator will flashes quickly 20 times.
Press function key to turn on the device which is in the network and the green indicator will flash
(2)
once and the device will send a data report after sampling (it takes 15 seconds to take sample). If
the device is not in the network, the indicator does not work.
4