Installing The Ub-E03 - Epson UB-E03 Technical Reference Manual

Installing the UB-E03

Follow the steps below to install the UB‐E03 on a TM printer.
WARNING
The display module connector on the TM printer cannot be used when the UB-E03 is
installed.
14
• Before installing the UB‐E03, disconnect the Power Unit from the TM
Printer (as well as turning the power switch off).
Even when the power switch is off, voltage is still present at some
points on the circuit board. Changing components while the Power
Unit is connected can cause damage to the UB‐E03 and the printer.
• Before installing the UB‐E03, be sure to set the DIP switches or
Memory switches as shown in the table below. For other models, ask
your dealer.
Model
TM-U200 Series
TM-U210 Series
TM-U220 Series
TM-U230 Series
TM-U325 Series
TM-U590 Series
TM-U675 Series
TM-T88 Series
TM-T90
TM-H5000/H5000II
TM-H6000 Series
TM-J2000/J2100
TM-L90
Setting
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 2-8: ON
DIP SW 2-8: ON
DIP SW 2-8: ON
MSW 2-8: ON
MSW 2-8: ON