Product Information; Parts Name And Function - Epson UB-E03 Technical Reference Manual

Product Information

Parts Name and Function

Ethernet interface connector
Ethernet interface connector
A LAN cable (RJ45 plug) can be connected to the Ethernet connector.
• 10BASE‐T, 100BASE‐TX Ethernet, full duplex, half duplex (Auto negotiation function, manual
setting)
• Complies with TCP/IP protocol (LP, LPR, and socket communications)
LED
The UB‐E03 has 2 LEDs. They are on in the following cases. However, they are off during the low
power consumption mode.
The green LED: when the Ethernet link is established.
The yellow LED: when the printer is sending/receiving Ethernet data.
Push button
A push button is provided to perform the following functions.
• Status sheet printing
Push and hold the push button for three seconds or more when the TM printer is ready for
printing (paper is set and the power supply is turned on); the network parameter status is
printed.
• Setting initialization
Push and hold the push button while turning on the power supply. Keep pushing the push
button (about ten seconds) until the initialization start massage (Resetting to Factory Default)
is printed. All settings are reset to the factory settings.
10
LED (Green) LED (Yellow)
Push button