Set Up; Flow Of Setup - Epson UB-E03 Technical Reference Manual

Set up

This chapter describes the procedures to set up an interface board for Epson TM printers, the
UB‐E03, so that you can use it on a network.

Flow of Setup

Follow the steps below for setup.
Use EPSON TMNet WinConfig or arp/ping command to set the IP address.
Setting IP Address Using
EPSON TMNet WinConfig
Installing TCP/IP Protocol in OS
Install TCP/IP protocol in your operating system.
Setting the UB-E03
Set IP address for the UB-E03 using
EPSON TMNet WinConfig.
Configure various settings for the UB-E03 using either one of the following methods.
EPSON TMNet WinConfig
Installing the UB-E03
Install the UB-E03 on a TM printer.
Setting IP Address Using
arp/ping Command
(page 17)
Set IP address for the UB-E03 using arp/ping
command.
Various Settings for the UB-E03
(page 29)
Web Browser
TM printer
+ UB-E03
(page 14)
(page 27)
(page 31)
Chapter 2 Set up
2
13