Section 9: Wiring; Wiring Safety Instructions - Grizzly T30943 Owner's Manual

SECTION 9: WIRING

These pages are current at the time of printing. However, in the spirit of improvement, we may make chang-
es to the electrical systems of future machines. Compare the manufacture date of your machine to the one
stated in this manual, and study this section carefully.
If there are differences between your machine and what is shown in this section, call Technical Support at
(570) 546-9663 for assistance BEFORE making any changes to the wiring on your machine. An updated
wiring diagram may be available. Note: Please gather the serial number and manufacture date of your
machine before calling. This information can be found on the main machine label.
SHOCK HAZARD. Working on wiring that
is connected to a power source is extreme-
ly dangerous. Touching electrified parts
will result in personal injury including but
not limited to severe burns, electrocution,
or death. Disconnect the power from the
machine before servicing electrical com-
ponents!
MODIFICATIONS. Modifying the wiring
beyond what is shown in the diagram
may lead to unpredictable results, includ-
ing serious injury or fire. This includes
the installation of unapproved aftermarket
parts.
WIRE CONNECTIONS. All connections
must be tight to prevent wires from loos-
ening during machine operation. Double-
check all wires disconnected or connected
during any wiring task to ensure tight con-
nections.
CIRCUIT REQUIREMENTS. You MUST
follow the requirements at the beginning of
this manual when connecting your machine
to a power source.
The photos and diagrams
included in this section are
best viewed in color. You
can view these pages in
color at www.grizzly.com.
-28
-

Wiring Safety Instructions

WIRE / COMPONENT
Damaged wires or components increase
the risk of serious personal injury, fire, or
machine damage. If you notice that any
wires or components are damaged while
performing a wiring task, replace those
wires or components.
MOTOR WIRING. The motor wiring shown
in these diagrams is current at the time of
printing but may not match your machine. If
you find this to be the case, use the wiring
diagram inside the motor junction box.
CAPACITORS/INVERTERS. Some capac-
itors and power inverters store an electrical
charge for up to 10 minutes after being
disconnected from the power source. To
reduce the risk of being shocked, wait at
least this long before working on capaci-
tors.
EXPERIENCING DIFFICULTIES. If you
are experiencing difficulties understanding
the information included in this section,
contact our Technical Support at (570)
546-9663.
Model T30943/T30944 (Mfd. Since 10/19)
DAMAGE .