Attaching Safety Strap; Operating Coolant System - Grizzly T30943 Owner's Manual

Attaching Safety Strap

During drilling operations the safety strap
is used to secure the tool to the workpiece.
This acts as a fail-safe in the event of
a power outage or some other type of
emergency that results in the magnet
failing and the tool becoming disconnected
from the workpiece.
To attach safety strap to drill:
1. Position tool on workpiece where drill-
ing operation will occur.
2. Turn magnet ON.
3. Position safety strap around workpiece
and through tool handle (see Figure
12), and cinch strap down tightly.
Workpiece
Figure 12. Example of tool secured with
safety strap.
4. Once drilling operation is complete,
remove safety strap, then turn magnet
OFF and remove tool from workpiece.
Model T30943/T30944 (Mfd. Since 10/19)
The Model T30943/T30944 uses a grav-
ity-fed coolant system that delivers fluid
directly into the spindle housing. Using
coolant will extend the life of the bits by
lowering operating temperatures and will
result in finer, cleaner cuts.
Do NOT use coolant system when
drilling in vertical or overhead posi-
tions. Coolant could drip into the
motor housing or control panel and
damage the tool.
To operate coolant system:
1. Ensure coolant bottle is filled with fresh
Handle
2. Position tool on workpiece where drill-
Strap
Operating
Coolant System
coolant (see Page 23).
ing operation will occur.
-17
-