Grizzly T30943 Owner's Manual page 17

To test run tool:
1. Clear away all setup/adjustment tools.
2. Press red OFF button (O) (see Figure
8), and turn spindle speed dial all the
way counterclockwise.
Spindle
Speed Dial
Magnet
ON/OFF Switch
Figure 8. Location of control panel
switches.
3. Connect tool to power supply.
4. Place tool on flat steel surface at
least ⁄ " thick. Toggle magnet ON/OFF
3
8
switch (see Figure 8) to (–) position to
turn magnet ON.
-14
-
Motor
ON/OFF Switch
5. Gently rock tool side to side to verify
magnet is adhering to surface. Tool
should not move.
6. With magnet ON/OFF switch still in ON
position, press green ON button (–)
(see Figure 8) to turn tool ON.
Note: Motor ON/OFF switch will not
function unless magnet ON/OFF
switch is already in ON position.
7.
Verify motor operation by slowly
turning spindle speed dial clockwise.
Rotate dial back and forth to test
variable-speed function. Motor should
run smoothly and without unusual
problems or noises.
8. Turn spindle speed dial all the way
counterclockwise, then press OFF
button on motor ON/OFF switch to
turn tool OFF.
9. Toggle magnet ON/OFF switch to (O)
position to turn magnet OFF.
Congratulations. Test run is complete.
Model T30943/T30944 (Mfd. Since 10/19)