Installing the Sunshade
Groundsmaster 3280 Machine
1.
With the roll bar in the raised position, remove
the hairpin cotters and the 2 pins
Figure 13
1. Roll bar
2. Pin
2.
Insert a washer (13/16 x 1-1/2 inches) onto each
bolt (3/4 x 4 inches) as shown in
Figure 14
1. Nut (3/4 inch)
2. Roll bar
3.
In the holes where the pins were removed,
install the bolts and washers
4.
Install another washer onto each bolt and
secure with nuts (3/4 inch) as shown in
14. Torque the nuts 323 to 396 N∙m (238 to 292
ft-lb).
5.
Torque the ROPS pivot bolt
113 N∙m (67 to 83 ft-lb) to avoid any bouncing of
the roll bar and sunshade.
(Figure
13).
g001199
3. Hairpin cotter
Figure
14.
g018100
3. Washer (13/16 x 1-1/2
inches)
4. Bolt (3/4 x 4 inches)
(Figure
14).
Figure
(Figure
14) 91 to
6.
Position the ROPS-mount bracket onto the top
of the traction unit roll bar
Note:
Make sure that the roll bar is centered in
the ROPS-mount bracket.
1. Bolt (1/2 x 2-1/2 inches)
2. Flange nut (1/2 inch)
7.
Install the frame assembly to the ROPS-mount
bracket
(Figure
8.
Using the mounting holes shown in
mount the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (4-7/8 x 2-3/4 inches)
and 4 flange nuts.
9.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 2-3/4 inches)
and 2 flange nuts.
1. Flange nut (3/8 inch)
10.
On each side of the sunshade frame, loosely
mount an extension link to the fourth hole of the
7
(Figure
15).
Figure 15
3. Flange nut (3/8 inch)
4. U-bolt (4-7/8 x 2-3/4
inches)
15).
Figure
Figure
Figure 16
2. U-bolt (3-7/8 x 2-3/4
inches)
g246185
15,
16,
g246187