7.
Position the ROPS-mount bracket onto the
top of the traction unit roll bar
Make sure that the roll bar is centered in the
ROPS-mount bracket.
Figure 27
1. Flange nut (3/8 inch)
2. Flange nut (1/2 inch)
8.
Using the mounting holes shown in
secure the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (4-7/8 x 4 inches) and
4 flange nuts.
9.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 4 inches) and
2 flange nuts.
Figure 28
1. Flange nut (3/8 inch)
(Figure
27).
g246190
3. Bolt (1/2 x 2-1/2 inch)
4. U-bolt (4-7/8 x 4 inches)
Figure
27,
Figure
28,
g246189
2. U-bolt (3-7/8 x 4 inches)
10.
On each side of the sunshade frame, loosely
mount a brace to the brace bracket as follows:
•
For Models 03820, 03821, 30604, 30605,
30608, and 30609 on each side of the
sunshade frame, loosely mount a brace to
the rear hole of the brace bracket with a
bolt (1/2 x 2-1/2 inches), washer (1/2 inch)
washer, and flange nut (1/2 inch) as shown
in
Figure
29.
•
For Models 30446, 30446N, 30447, and
30447N, on each side of the sunshade
frame, loosely mount a brace to the second
hole of the brace bracket with a bolt (1/2 x
2-1/2 inches), washer (1/2 inch), and flange
nut (1/2 inch) as shown in
Models 03820, 03821, 30604, 30605, 30608, and 30609
1. Flange nut (1/2 inch)
2. Mount hole
3. Washer (1/2 inch)
4. Bolt (1/2 x 2-3/4 inches)
12
Figure
30.
Figure 29
5. Bolt (1/2 x 2-1/2 inches)
6. Brace
7. Brace bracket
g267177