Table of Contents
Advertisement
Installing the Sunshade
Groundsmaster 3200 or 3300
Machine
1.
With the roll bar in the raised position, remove
the hairpin cotters and the 2 pins
1. Roll bar
2. Pin
2.
Insert a washer (13/16 x 1-1/2 inches) onto each
bolt (3/4 x 4 inches) as shown in
1. Nut (3/4 inch)
2. Roll bar
3.
In the holes where the pins were removed,
install the bolts and washers
4.
Install another washer onto each bolt and secure
with nuts (3/4 inch) as shown in
the nuts 323 to 396 N∙m (238 to 292 ft-lb).
5.
Torque the ROPS pivot bolt
N∙m (67 to 83 ft-lb) to avoid any bouncing of the
roll bar and sunshade.
(Figure
Figure 6
3. Hairpin cotter
Figure
Figure 7
3. Washer (13/16 x 1-1/2
inches)
4. Bolt (3/4 x 4 inches)
(Figure
7).
Figure
7. Torque
(Figure
7) 91 to 113
6.
Position the ROPS-mount bracket onto the top
of the turf sprayer roll bar
Note:
the ROPS-mount bracket.
6).
1. Bolt (1/2 x 2-1/2 inches)
g001199
2. Flange nut (1/2 inch)
7.
Install the frame assembly to the ROPS-mount
bracket
7.
8.
Using the mounting holes shown in
mount the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (4-7/8 x 2-3/4 inches)
and 4 flange nuts.
9.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 2-3/4 inches)
and 2 flange nuts.
g018100
1. Flange nut (3/8 inch)
5
(Figure
Make sure that the roll bar is centered in
Figure 8
3. Flange nut (3/8 inch)
4. U-bolt (4-7/8 x 2-3/4
inches)
(Figure
8).
Figure 9
2. U-bolt (4-7/8 x 2-3/4
inches)
8).
g246185
Figure
9,
Figure
43,
g262468
Advertisement
Table of Contents
