Installing the Sunshade
Multi Pro 1750 Machine
1.
Position the ROPS-mount bracket onto the top
of the turf sprayer roll bar
Note:
Make sure that the roll bar is centered in
the ROPS-mount bracket.
Figure 42
1. Bolt (1/2 x 2-1/2 inches)
2. Flange nut (1/2 inch)
2.
Install the frame assembly to the ROPS-mount
bracket
(Figure
42).
3.
Using the mounting holes shown in
mount the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (4-7/8 x 2-3/4 inches)
and 4 flange nuts.
4.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 2-3/4 inches)
and 2 flange nuts.
Figure 43
1. Flange nut (3/8 inch)
(Figure
42).
g246185
3. Flange nut (3/8 inch)
4. U-bolt (4-7/8 x 2-3/4
inches)
Figure
42,
Figure
43,
g262468
2. U-bolt (3-7/8 x 2-3/4
inches)
5.
On each side of the sunshade frame, loosely
mount an extension link to the fourth hole of the
brace mount with 2 bolts (1/2 x 2-3/4 inches),
and 2 flange nuts (1/2 inch) as shown in
44.
1. Flange nut (1/2 inch)
2. Mount hole
3. Brace
4. Washer (1/2 inch)
6.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
44.
7.
Move the brace brackets up or down on the
vertical roll bar posts until the sunshade frame
is level to the ground, then tighten the U-bolt
flange nuts, securing the mounting brackets to
the posts.
Note:
Use a level to make sure that the frame
is level to the ground.
8.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
9.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
17
Figure 44
5. Bolt (1/2 x 2-3/4 inches)
6. Brace bracket
7. Bolt (1/2 x 2-1/2 inches)
Figure
Figure
g267174
45.