11.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
36.
12.
Move the brace brackets up or down, on the
vertical roll bar posts, until the sunshade frame
is level to the floor.
Note:
Use a level to make sure that the frame
is level to the ground.
13.
Tighten the U-bolt flange nuts, securing the
mount brackets to the posts.
14.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
15.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
Figure 37
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
16.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet
37).
17.
Tighten the sunshade-mounting bolts to 5 to 6
N∙m (45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
Figure
g245151
3. Grommet
4. Clip nut
(Figure
Installing the Sunshade
Reelmaster 5010 Machine or
Groundsmaster 4300 Machine
1.
Position the ROPS-mount brackets onto the
top of the traction unit roll bar
Make sure that the roll bar is centered in the
ROPS-mount bracket.
37.
1. Flange nut (3/8 inch)
2. Flange nut (1/2 inch)
2.
Using the mounting holes shown in
mount the ROPS-mount bracket to the top of
the roll bar with 2 U-bolts (4-7/8 x 2-3/4 inches)
and 4 flange nuts.
3.
Using the mounting holes shown in
loosely secure each of the brace brackets to the
roll bar posts with a U-bolt (3-7/8 x 4 inches) and
2 flange nuts.
1. Flange nut (3/8 inch)
15
(Figure
38).
Figure 38
3. Bolt (1/2 x 2-1/2 inch)
4. U-bolt (4-7/8 x 2-3/4
inches)
Figure
Figure
Figure 39
2. U-bolt (3-7/8 x 4 inches)
g246190
38,
39,
g246191