Table of Contents
Advertisement
brace mount with 2 bolts (1/2 x 2-3/4 inches),
and 2 flange nuts (1/2 inch) as shown in
17.
1. Flange nut (1/2 inch)
2. Mount hole
3. Brace
4. Washer (1/2 inch)
11.
Loosely install a brace bracket to each brace
with a bolt (1/2 x 2-1/2 inches), washer (1/2
inch), and flange nut (1/2 inch) as shown in
Figure
17.
12.
Move the brace brackets up or down on the
vertical roll bar posts until the sunshade frame
is level to the ground, then tighten the U-bolt
flange nuts, securing the mounting brackets to
the posts.
Note:
Use a level to make sure that the frame
is level to the ground.
13.
Tighten all the remaining flange nuts as follows:
•
Torque the flange nuts (3/8 inch) 41 to 55
N∙m (34 to 41 ft-lb).
•
Torque the flange nuts (1/2 inch) 113 to 141
N∙m (84 to 104 ft-lb).
14.
While aligning the mounting holes, position the
sunshade onto the frame as shown in
Figure 17
5. Bolt (1/2 x 2-3/4 inches)
6. Brace bracket
7. Bolt (1/2 x 2-1/2 inches)
Figure
Figure
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
g267174
15.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet
18).
16.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
bolts as the sunshade may crack.
18.
8
Figure 18
3. Grommet
4. Clip nut
Do not overtighten the mounting
g245151
(Figure
Advertisement
Table of Contents
