Table of Contents
Advertisement
1. Flange-head bolt (5/16 x
1-1/4 inches)
2. Small washer
10.
Loosely mount each corner of the sunshade to
the frame with a flange-head bolt (5/16 x 1-1/4
inches), a small washer, and a grommet
45).
11.
Tighten the sunshade-mounting bolts 5 to 6 N∙m
(45 to 55 in-lb).
Important:
Do not overtighten the mounting
bolts as the sunshade may crack.
Figure 45
3. Grommet
4. Clip nut
Operation
Transporting the Machine
When transporting the machine, use the 2 holes in
the front of the sunshade frame (under the sunshade)
to tie down the sunshade to a secure location on the
machine and prevent it from raising up in the wind
(Figure
46).
g245151
(Figure
1. Tie down holes
Maintenance
Checking and Tightening
the Hardware
Check and tighten the mounting hardware after 8
hours of operation. Periodically inspect and tighten
the hardware.
Cleaning the Sunshade
Wash with a mild soap or detergent using your bare
hands, soft cloth, or sponge to free or dislodge any
caked-on dirt or other foreign particles.
Note:
Using some cleaners or cloths may scratch or
degrade the surface of the sunshade. Test the cleaner
or cloth in an inconspicuous area.
18
Figure 46
g018101
Advertisement
Table of Contents
