The Timer; Setting/Changing The Time; Semi-Automatic And Fully Automatic Operation - Hanseatic 5022IE2.323eEHiTaDJW User Manual

The timer

Setting/changing the time

Setting the time
During initial commissioning or after a pow-
er failure, the display flashes '
dicates that the time must be set. To do so,
proceed as follows:
1. Press the 'OK' button once.
The display shows the symbol " ", the dot
underneath flashes.
2. Set the time using the arrow buttons "<"
or ">".
Shortly after the last keystroke, the dot
stops flashing. The time is now saved.
Changing the time
This is necessary e.g. when changing to and
from summer time.
Requirements:
– The timer switch must not be in automatic
mode and
– the countdown timer must not be active.
1. Press the two arrow keys '<' and '>' simul-
taneously.
The dot beneath the symbol " " flashes.
2. Set the time using the arrow buttons "<"
or ">".
To quickly go forwards/backwards,
hold the corresponding button down.
Semi-automatic and fully
automatic operation
WARNING
'. This in-
Please ensure that you always observe
the following when using the automat-
ic timer:
Please make sure to inform all mem-
■
bers of the household so that they do
not put anything in the oven.
Monitor the oven in order to prevent
■
spills and burning.
Take special care when roasting: Fat,
■
oil and alcohol can ignite.
Never leave anything to grill unat-
■
tended when using the timer!
The timer does not control the switch-
■
ing on and off of the hob.
After use, set the function selector
■
and the temperature controller to
»0«.
All settings will be deleted in the case
■
of a power failure.
The correctly set time is a prerequisite.
– You can pre-programme up to 23 hours
and 59 minutes in advance.
– The cooking time can be set between 1
minute and 10 hours.
– Any programming will be deleted in the
case of a power failure.
– A tone sounds to signal the end of the pro-
gramme, which you can cancel by pressing
any button.
Page EN-27
The timer