Chapter 5 Copy Function And Operation - Hitachi SRW-0J Instruction Manual

5.1 Copy Function
1. The copy function can be used only while the inverter stops. While the inverter is running,
tripping, reset or soft-locked, the function is invalidated.
Press the Read key or copy key. The following display will appear corresponding to the
2.
entered key. When the copying ends, the display will go back to the before one.
WRITER INV →→ REMT
3. If any set data is updated after some data is read the inverter, the data is updated only
in the inverter. To read the updated data from the inverter into a remote operator, press
the Read key again.
4. The data read into a remote operator can be held even when the power supply of the
inverter is turned OFF.
5. Copying data between inverters is possible only between the same type ones. (When
copying is done between different type inverters ,will display error message and copy
function will stop.)
6. In order to protect the data in the remote operator, a function to inhibit transferring data
from inverter to remote operator and reading data from inverter is provided. To use this
function read 5.2 please.
7. Refer to the each inverter instruction manual about the object item of READ /COPY .
8. When pressing any key or resetting the unit or the power is turned off after the READ
key /COPY key is pressed , be sure to wait for at least ten seconds.
READ
WRITER REMT →→ INV

Chapter 5 Copy function and operation

COPY