PC RLH8/ WIRELESS RECEIVER KIT INSTALLATION AND OPERATION MANUAL MANUAL DE INSTALAÇÄO E DE MANUAL DE INSTALACIÓN Y FUNCIONAMIENTO FUNCIONAMENTO INSTALLATIONS- UND BETRIEBSHANDBUCH BRUGER- OG MONTERINGSVEJLEDNING MANUEL D’INSTALLATION ET DE INSTALLATIE- EN BEDIENINGSHANDLEIDING FUNCTIONNEMENT HANDBOK FÖR INSTALLATION OCH ANVÄNDING ÅÃ×ÅÉÑÉÄÉÏÅÃÊÁÔÁÓÔÁÓÇÓÊÁÉËÅÉÔÏÕÑÃÉÁÓ MANUALE D’INSTALLAZIONE E D’USO Do not perform installation work, without referring to our installation manual.
If poured, it will cause a serious electrical shock. WARNING: DO NOT perform installation work and electrical wiring connection by yourself. Contact your distributor or dealer of HITACHI and ask them for installation work and electrical wiring by service person. CAUTION: DO NOT install the indoor unit, outdoor unit, at such places as: Where there is oil vapor and the oil is dispersed.
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10 INSTALLATION OF WIRELESS RECEIVER KIT CAUTION: Pay attention to the following installation procedures. If not, it may drop from the panel, resulting in a serious accident. PC-RLH8 1) Install the wireless receiver kit, the indoor unit and the air panel at the same time.
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10 5) Draw out the connecting cable from the wiring hole of the indoor unit, and lead the cable over the suspension bracket of the indoor unit to the installing position of the receiver kit. Bundle the extra cable with a band.
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10 8) Hook other fixixng nails (3 postions) at square holes of air panel. NOTE: When removing the receiver kit after installing the air panel; 1) The corner position of the receiver kit Coin or"-" Shaped Driver can be lifted when a coin or a “-”...
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10 5) Install the wireless receiver kit to the drain pan. (1) Insert the cable through the hole for wiring. (2) Install the wireless receiver kit completely. Check to nesure that there is no gap between wireless receiver kit and drain pan.
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10 7) Remove the cover of indoor unit electrical control box and connect the cable to the terminals A and B of the terminal board (white). NOTE: After connecting the cable, bind up the remaining cable lenght portion by band (Factory-Supplied) and put them in electrical control box.
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10 OPTIONAL FUNCTIONS 1) Open the lid of case by removing two screws so that the following functions are available. PC-RLH8 Switch "COOL" Switch "HEAT" Remove the screw Dip Switch (SW3; Factory Supplied) Cover Rear Side of Indoor Unit...
OPERATION & INSTALLATION MANUAL FOR PC-RLH8/10 OTHERS 1) Proceed the "TEST RUN" mode by using "Operation & Installation Manual" for the wireless remote control switch (PC-LH3A). Turn OFF all power sources before setting the dip switches. 2) Emergency Operation Setting (Refer to the figure of the item 3 "Optional Functions".) In case that PC-LH3A is unusable by batteries shortage, etc., perform emergency operation as...