Series Rigging Components; Locking Pins - d&b audiotechnik Z5458 Rigging Manual

2 A-Series rigging components
d&b Z5458
AL Base plate Rigging manual 1.1 en

2.1 Locking pins

WARNING!
Potential risk of personal injury and/or
damage to material!
The steel wires of the Locking pins are not intended to carry any
load. The cabinet's weight must only be carried by the Front and
Splay/Rear links in conjunction with the front and rear rigging
strands of the loudspeaker cabinets and the rigging components.
Ensure all Locking pins are fully inserted and securely locked
before lifting any load.
The A-Series loudspeaker cabinets and rigging components are
equipped with a Locking pin 5 x 35 mm.
Note: The Locking pins are undetachably attached to the
different rigging components on the cabinet using steel wires.
Throughout this manual these steel wires are not shown in the
corresponding illustrations.
Functionality (Quick lock mechanism)
Proceed as follows:
1. Press the button to release the locking mechanism (
2. Remove the Locking pin through the respective link or socket.
3. Insert the Locking pin through the respective link or socket until
it is fixed in place.
4. Release the button to lock the pin (
5. Recheck the Locking pin is securely locked by briefly pulling
the Locking pin towards you.
A-Series rigging components
[r]).
[l]).
5