Pc Card Handling; Inserting The Pc Card; Ejecting The Pc Card - Toshiba SL-5300 Series Owner's Manual

12. PC CARD HANDLING

12. PC CARD HANDLING
This scale allows a use of commercially available PC cards (conforming to Types I to III). Regarding
the available PC card types, please refer to your TOSHIBA TEC service representative.
In this section, how to insert or eject a PC card is described.
CAUTION!
1. Do not insert or eject a PC card while the scale power is on. Doing so may destroy the data stored
in the PC card or PC card itself.
2. Do not eject a PC card or turn off the power while the PC card is being accessed. Doing so may
destroy the data stored in the PC card or PC card itself.
NOTES: 1. PC cards of Type I to Type III conforming to PCMCIA2.1JEIDA4.2 are available. However,
two Type III PC cards cannot be used at the same time.
2. For details of PC card handling, please refer to each PC card's instruction.

12.1 Inserting the PC Card

1. Turn off the power switch, and open the interface cover by pushing the portion indicated by the
arrow.
2. Hold the PC card so that the front side faces up and the arrow mark points to the card slot, and
slowly insert it into the slot until it stops.
3. Turn on the power switch.

12.2 Ejecting the PC Card

1. First, make sure that the PC card is not being accessed, then, turn off the power switch.
2. Press the eject button and the PC card will pop out of the card slot. Pull it out straight.
Interface Cover
PC Card Slot
Eject Button
Arrow
Mark
PC Card
12- 1
12.1. Inserting the PC Card
PC Card
EO1-31009