Toshiba SL-5300 Series Owner's Manual page 145

15. SET UP MODE
Procedure
Item
Setting the ESS ID
Setting the encryption
status
Selecting the WEP key type
Setting the transmit key
Setting Authentication
Default key number
Setting Antenna
NOTES:
1. ESSID (Extended Service Set Identifier (IEEE802.11))
Max. 32 characters (32 byte ASCII)
The vacant area should be set to zero. The default setting is zero.
2. Encryption (Enable/Disable, WEP type, eacp WEP key code)
ASCII 5 characters or 10 digit HEX code.
All digits should be filled, or an error occurs and entered data is cleared.
The default setting is all zeros, which means the encryption is disabled.
Level
40 bit
128 bit
3. Authentication (Open-system/Shared-key)
It depends on the Access Point setting.
1. Touch the ESS ID area.
2. The Edit screen will appear.
3. Input an alphanumeric data. (Refer to NOTE 1.)
Touch the Yes or No area. When the Yes area is touched, the WEP
type and WEP key code settings will be effective. (Refer to NOTE 2.)
Touch the ASCII or HEX area.
1. Touch the Transmit key area.
2. The Edit screen will appear.
3. Enter a transmit key name.
Touch the Open-system or Shared-key area. (Refer to NOTE 3.)
Select one of the transmit keys. Each time the Default Key No. window
is touched, the displayed number changes among 1 to 4.
1. Touch the Antenna selection area.
2. The following menu will appear.
3. Select the Diversity, ANTENNA-A, or ANTENNA-B.
Key length
0x + 10 digits
0x + 26 digits
Procedure
ASCII
5 characters
Disabled
15-50
EO1-31009
15.7 Wireless LAN
Example
0xABCDE23456
26 digits = 5+4+4+4+4