Toshiba 18 - 1250 A Instruction Manual page 24

Low voltage digital solid state startern 18–1250a
Table of Contents

Advertisement

TE Series
Figure 4.2: Control Terminal Blocks
1
2
NC
NO.
C
NC
NO.
C
Figure 4.2.1
Control Pow er Supply Connection
TB-2
4.2.1 AC Control Power Supply Connection
120VAC
Separate AC Control Power supply is required to power the electronics
Supply
of the TE Series starter. 120VAC is standard, order 240 VAC (optional)
if necessary for your line power supply configuration. The control
3
1
NO.
C
A1 A2
voltage must be connected to terminals marked A1 and A2 of TB-2 as
shown in figure 4.2.1 (these are also Terminal #s 21 and 22). This
control voltage must be customer supplied, unless an optional control
power transformer (see table below) has been supplied with the unit.
TE ...-BP
Model
TE-18 to 48
TE-62 to 112
TE-150 to 160
TE- 210 to 276*
TE-360 to 450*
TE-550 to 900*
TE-1006 to 1250*
Table 3: TE Series Control Power Requirements
NOTE: * - P versions (w/o bypass) still require PCB and fans, plus user supplied bypass (if any).
4
.2.1.a
When sizing a control power transformer for the TE...-BP Series
starter use the above chart for minimum sizes or supply capacity.
Any additional control devices powered by the same CPT must be
added to the above figures to ensure proper operation of the
Bypass Contactor.
NOTE:
TE-210 and larger units are available without the Bypass Contactor,
but fans are still included. CPT can be sized for fan loads only if
used in NEMA 1 ventilated enclosures.
4.2.1.b
Output relays in TB2 must be protected from currents in excess of
5A, either with a fuse or with other suitable current protection
devices.
A dedicated fault output for use in PLC or interposing relay control
is available on TB1. This opto-isolated Triac switch is rated for
50mA max., 10-250V AC/DC. Any circuit connected to it must be
fused accordingly.
Digital Solid State Soft Starters 18 – 1250A
AC Control Power VA Requirements
-BP: Bypass
PC
Fans
Contactor
Boards
48
(inc. in PCB)
48
(inc. in PCB)
48
72
48
100
48
150
48
200
48
200
Control Power Requirements
Control Fusing
17
-BP: Bypass
Contactor
Inrush
Sealed
95
9
220
17
298
12.3
380
11.6
571
14
600
3.3
1900
48
Recommended
minimum
CPT
Rating
100
250
500
500
750
750
2000

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Te series

Table of Contents