Teledyne 5800 Removal And Replacement page 8

Instruction Sheet 60-4702-048 Revision H, November 8, 2019
11
c. With the / " wrench, connect the green and
32
yellow ground wire with the nut to the
threaded standoff on the frame.
Note
The black wire from the heater is not utilized.
16. Reinstall the terminal cover that was removed in
step 6.
17. Connect the green/yellow ground wire from the
module chassis to the compressor with the
included screw and lock washer.
CAUTION
Earth ground bonding conductor. Ensure the
green/yellow wire is reconnected to this
terminal.
18. Slide the refrigeration module to the rear of the
refrigerator and place the drain tube in the drip
pan on the module (Figure 24).
Figure 24: Position drain tube in front half of drip pan.
19. Ensure the black gasket is aligned and gasket
nubs are inserted in corresponding holes on the
frame of the refrigerator module (Figure 25).
Figure 25: Position gasket on refrigeration module
frame and ensure each gasket nub is inserted in
corresponding hole
20. Route the AC power cord through the
refrigeration module and secure it in place with
the bushing (Figure 26).
Gasket
Nub
Figure 26: Secure AC Power Cord (Full length of line
cord not depicted)
CAUTION
When reinstalling the refrigeration module, do not pinch
the sensor wiring.
21. Install the module, tipping the top back while
sliding the bottom forward. When the bottom of
the system is in place, push the top into place
(Figure 27). Ensure the slack in the power cord is
removed before securing refrigeration module
frame.
Figure 27: Slide module into place
CAUTION
When reinstalling all self-tapping screws, avoid
destroying the plastic threads. First seat each screw in
its hole and, without pressing down, rotate the screw
counter-clockwise until it falls into its thread groove with
a "click." Then tighten the screw.
22. Reinstall the refrigeration module mounting
screws (Step 4).
Bushing
Push top
in
second.
Push
bottom in
first.