Teledyne 5800 Removal And Replacement page 4

Instruction Sheet 60-4702-048 Revision H, November 8, 2019
Figure 10: Position gasket on refrigeration module
frame and ensure each gasket nub is inserted in
corresponding hole
17. Route the AC power cord through the
refrigeration module and secure it in place with
the bushing (Figure 11).
Figure 11: Secure AC Power Cord (Full length of line
cord not depicted)
CAUTION
When reinstalling the refrigeration module, do not pinch
the sensor wiring.
Gasket
Nub
Bushing
18. Install the module, tipping the top back while
sliding the bottom forward. When the bottom of
the system is in place, push the top into place
(Figure 12). Ensure the slack in the power cord is
removed before securing refrigeration module
frame.
Figure 12: Slide module into place
CAUTION
When reinstalling all self-tapping screws, avoid
destroying the plastic threads. First seat each screw in
its hole and, without pressing down, rotate the screw
counter-clockwise until it falls into its thread groove with
a "click." Then tighten the screw.
19. Reinstall the refrigeration module mounting
screws (Step 4).
20. Install the cable tie to secure the power cord
that runs through the refrigeration assembly
(Figure 13).
CAUTION
During reinstallation, Ensure the slack in the power cord
is removed before securing refrigeration module frame.
Figure 13: Install cable tie to secure power cord
Push top
in
second.
Push
bottom in
first.
Install
cable tie