LG 32SE3D Owner's Manual page 107

46. Status Check (Command: s v)
Checks the current signal of the product.
Transmission
[s][v][ ][Set ID][ ][Data][ ][FF][Cr]
Data 02: Checks whether there is a signal
03: The monitor is currently in PM Mode
05: Checks whether luminance sensors 1 and 2
are functioning properly.
06: Luminance sensors currently being used:
07: Checks whether the Top, Bottom and Main
temperature sensors are functioning normally.
08: The temperature of each temperature sensor
when the monitor set was last powered off.
09: Fan speed
10: RGB Sensing OK/NG (screen fault detection)
Acknowledgment
[v][ ][Set ID][ ][OK/NG][Data][Data1][x]
Data 02 (when a signal is found)
Data 1 00: No signal
01: Signal present
Data 03 (when the monitor is currently in PM mode)
Data 1 00: Screen On is activated.
01: Screen Off is activated.
02: Screen Off Always is activated.
03: Sustain Aspect Ratio is activated.
04: Screen Off & Backlight is activated.
Data 05 (when checking whether the luminance
sensors are functioning properly)
Data 1 00: All senors normal
01: BLU sensor 1 normal, BLU sensor 2 down
02: BLU sensor 1 down, BLU sensor 2 normal
03: All sensors down
Data 06 (when checking which luminance sensor is in
use)
Data 1 00: Luminance sensor 1 is in use.
01: Luminance sensor 2 is in use.
Data 07 (when checking whether the Top, Bottom and
Main temperature sensors are working properly)
Data 1 00: All temperature sensors faulty
01: Top normal, Bottom faulty, Main faulty
02: Top faulty, Bottom normal, Main faulty
03: Top normal, Bottom normal, Main faulty
04: Top faulty, Bottom faulty, Main normal
05: Top normal, Bottom faulty, Main normal
06: Top faulty, Bottom normal, Main normal
07: All temperature sensors are normal
Data 10 (when executing Screen Fault Detection)
Data 1 00: Screen Fault Detection result NG
07: Screen Fault Detection result OK
* When screen Fault Detection is set to Off or not supported,
execution results are rendered "NG."
Data (when checking the temperature of each
temperature sensor when the monitor set was
last powered off)
Acknowledgment
[v][ ][Set ID][ ][OK/NG][Data][Data1]
[Data2][Data3][x]
Data 1 The temperature of the Top sensor when the
monitor set was last powered off.
Data 2 The temperature of the Bottom sensor when the
monitor set was last powered off.
Data 3 The temperature of the Main sensor when the
monitor set was last powered off.
Data 09 (when checking the fan speed)
Acknowledgment
[v][ ][Set ID][ ][OK/NG][Data][Data1][Data2][x]
Data 1 00-ff: The upper 1-byte of the fan speed
Data 2 00-ff: The lower 1-byte of the fan speed
Fan speed: 0 to 2008 in hexadecimal and 0 to 8200 in
decimal
* This feature may not be supported on some models.
47. Screen Fault Detection (Command: t z)
Sets the Screen Fault Detection feature.
Transmission
[t][z][ ][Set ID][ ][Data][Cr]
Data 00: Off
01: On
Acknowledgment
[z][ ][Set ID][ ][OK/NG][Data][x]
* This feature may not be supported on some models.
67