LG 55SE3KD Owner's Manual
Hide thumbs Also See for 55SE3KD:

Advertisement

Quick Links

OWNER'S MANUAL
LG Digital
Signage
(MONITOR SIGNAGE)
Please read this manual carefully before operating your set and retain it
for future reference.
32SE3D
32SE3KD
43SE3D
43SE3KD
49SE3D
49SE3KD
55SE3D
55SE3KD
65SE3D
65SE3KD
www.lg.com

Advertisement

Table of Contents
loading

Summary of Contents for LG 55SE3KD

  • Page 1 OWNER’S MANUAL LG Digital Signage (MONITOR SIGNAGE) Please read this manual carefully before operating your set and retain it for future reference. 32SE3D 32SE3KD 43SE3D 43SE3KD 49SE3D 49SE3KD 55SE3D 55SE3KD 65SE3D 65SE3KD www.lg.com...
  • Page 2: Table Of Contents

    - Connecting the Stand ..........15 - Connecting the Speakers ..........17 - Using the IR Receiver ...........20 - Portrait Layout ..............21 - Attaching and removing the LG Logo Bracket ................22 - Installing on a Wall ............24 REMOTE CONTROL ....26 - Displaying the Device Name Connected to an Input Port ................28...
  • Page 3: Safety Precautions

    WARNING - This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. SAFETY PRECAUTIONS Please read these safety precautions carefully before using the product. WARNING If you ignore the warning message, you may be seriously injured or there is a possibility of accident or death.
  • Page 4 If you install the product in a place that does not meet the recommended conditions, this may cause serious damage to the product’s picture quality, life cycle, and appearance. Please check with LG or a qualified installer before installing. This caution applies to a place where there is an abundance of fine dust or oil mist, chemical substances are used, the temperature is very high or low, the humidity is very high, or the product is likely to remain turned on for a long period of time (airport and train station), failure to do so will invalidate the warranty.
  • Page 5: Precautions For Using Ac Adapter And Electrical Power

    - If loosely connected, the poor connection may cause a fire or electric shock. • Be sure to use power cords and AC adapters provided or approved by LG Electronics, Inc. - The use of non-approved products may cause a fire or electric shock.
  • Page 6 • If you don’t intend to use the product for a long time, unplug the power cable from the product. - Covering dust can cause a fire, or insulation deterioration can cause electric leakage, electric shock or fire. • Fix the power cable completely. - If the power cable is not fixed completely, a fire can break out.
  • Page 7: Precautions For Moving The Product

    Precautions For Moving the Product WARNING • Make sure to turn off the product. - You may be electrocuted or the product can be damaged. • Make sure to remove all cables before moving the product. - You may be electrocuted or the product can be damaged. •...
  • Page 8: Precautions For Using The Product

    Precautions For Using the Product WARNING • Do not disassemble, repair or modify the product at your own discretion. - Fire or electric shock accident can occur. - Contact the service center for check, calibration or repair. • When the display is to be left unattended for an extended period of time, unplug it from the wall outlet. •...
  • Page 9: Mounting On A Wall

    • Spray water onto a soft cloth 2 to 4 times, and use it to clean the front frame; wipe in one direction only. Too much moisture may cause staining. CHEMICALS WATER • Do not use products using high voltage around the Monitor. (e.g., a bug zapper) - Monitor may have malfunction as its electrical shock.
  • Page 10: Licenses

    LICENSES Supported licenses may differ by model. For more information of the licenses, visit www.lg.com. The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.
  • Page 11: Assembly And Preparation

    SuperSign Software & Manual - Downloading from the LG Electronics website. - Visit the LG Electronics website (http://partner.lge.com) and download the latest software for your model. • The warranty will not cover any damage caused by using the product in an excessively dusty environment.
  • Page 12: Optional Accessories

    Optional Accessories Without prior notice, optional accessories are subject to change to improve the performance of the product, and new accessories may be added. The illustrations in this manual may differ from the actual product and accessories. Stand kit Screws Diameter 4.0 mm x Pitch 0.7 mm Stand Spacers Stand...
  • Page 13 Media Player kit (It may not be supported depending on the model.) Screws Media Player Diameter 3.0 mm x Pitch 0.5 mm CD (Owner’s Manual)/ Cards MP500/ MP700 x Length 6mm Wi-Fi Dongle kit AN-WF500 NOTE • Cable holder/Cable tie may not be available in some areas or for some models. •...
  • Page 14: Parts And Buttons

    Parts and Buttons The image may be different according to the model. Buttons • INPUT: Changes the input source. MENU: Accesses the main menus, or saves your input and exits the menus. • • : Adjust the up and down. •...
  • Page 15: Connecting The Stand

    Connecting the Stand - For certain models only. - The image may be different according to the model. 32SE3*...
  • Page 16 43/49/55/65SE3*...
  • Page 17: Connecting The Speakers

    Connecting the Speakers - For certain models only. - The image may be different according to the model. 32SE3D Connect an input signal cable before installing the speakers. Mount the speakers by using screws as shown below. Make sure the power cable is disconnected before making a connection.
  • Page 18 Then connect the speaker cable. After installing your speakers, use holders and cable ties to organize the speaker cables. Basic installation...
  • Page 19 43/49/55/65SE3D Connect an input signal cable before installing the speakers. Mount the speakers by using screws as shown below. Make sure the power cable is disconnected before making a connection. Then connect the speaker cable. After installing your speakers, use holders and cable ties to organize the speaker cables.
  • Page 20: Using The Ir Receiver

    Using the IR Receiver - The image may be different according to the model. This allows a remote control sensor to be placed in a custom location. Then that display can control other displays via an RS-232C cable. Install the IR receiver towards the front of the set. IR Receiver cable NOTE •...
  • Page 21: Portrait Layout

    Portrait Layout When installing in a portrait layout, rotate the monitor counterclockwise 90 degrees (when facing the screen). Using Kensington Lock (This is not available for all models.) The Kensington security system connector is located at the back of the monitor. For more information on installation and use of this system, refer to the manual provided with the Kensington security system or visit http://www.kensington.com.
  • Page 22: Attaching And Removing The Lg Logo Bracket

    LG Logo Bracket to the bottom rear of the monitor. LG Logo Bracket After removing the screw, remove the LG Logo Bracket. When re-attaching the LG Logo Bracket, repeat the process in reverse order.
  • Page 23 LG Logo Bracket to the bottom rear of the monitor. After removing the screw, remove the LG Logo Bracket. Attach the LG Logo Bracket with a screw, aligning it with the hole on the right side.
  • Page 24: Installing On A Wall

    Screws which are longer than standard length may damage the inside of the monitor. A non-VESA standard screw may damage the product and cause the monitor to fall. LG Electronics is not liable for any accidents related to the use of non-standard screws.
  • Page 25 Disconnect the power cord before moving or installing the monitor to avoid risk of electric shock. • If you install the monitor on a ceiling or slanted wall, it may fall and result in injury. Use an authorized LG wall mount and contact your local dealer or qualified personnel to assist with the installation.
  • Page 26: Remote Control

    REMOTE CONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully to use the monitor correctly. To install batteries, open the battery cover, place batteries (1.5 V AAA) matching terminals to the labels inside the compartment, and close the battery cover. To remove the batteries, perform the installation actions in reverse.
  • Page 27 PSM Selects the Picture Mode. INFO Views the information of the currently program and the screen. W.BAL Enters the White Balance menu. SETTINGS Accesses the main menus or saves your input and exit menus. S.MENU SuperSign menu key. Navigation Buttons Scrolls through menus or options. Selects menus or options and confirms your input.
  • Page 28: Displaying The Device Name Connected To An Input Port

    Displaying the Device Name Connected to an Input Port Display which devices are connected to which external input ports. Access the Input list screen and press the red (input label) button on the remote control. You can assign an input label for every input except USB. NOTE •...
  • Page 29: Making Connections

    MAKING CONNECTIONS You can connect various external devices to your monitor. Change the input mode and select the external device you want to connect. For more information about external device connections, see the user manual provided with each device. Connecting to a PC Some of the cables are not provided.
  • Page 30 NOTE • For the best image quality, using the monitor with HDMI connection is recommended. • To comply with the specifications of the product, use a shielded interface cable with ferrite core, such as a D-sub 15-pin cable and DVI-D/HDMI cable. •...
  • Page 31: Troubleshooting

    TROUBLESHOOTING No image is displayed. Problem Action Is the product power cord connected? • Check if the power cord is correctly plugged into the power outlet. Does the “Invalid Format” message • The signal from the PC (Graphics card) is out of the vertical or appear? horizontal frequency range of the product.
  • Page 32 After-image appears on the product. Problem Action After-image appears when the product is • If you use a fixed image for a long time, the pixels may be damaged. turned off. Use the screen-saver function. • When a dark image is displayed on the screen after an image with high contrast (black and white or gray), this may cause image sticking.
  • Page 33 CAUTION • Image sticking does not occur when using constantly changing images but may occur when using a fixed image for an extended period of time. Therefore, it is recommended that you use the instructions below to decrease the likelihood of image sticking occurring when using a fixed image.
  • Page 34: Product Specifications

    PRODUCT SPECIFICATIONS The product specifications below may be changed without prior notice due to upgrade of product functions. “ ” refers to alternating current (AC), and “ ” refers to direct current (DC). LCD screen Screen type Thin Film Transistor (TFT) Liquid Crystal Display (LCD) Screen Video signal Maximum resolution...
  • Page 35 32SE3D 0.36375 mm (H) x 0.36375 mm (V) LCD screen Pixel pitch AC 100-240 V ~ 50/60 Hz 0.8 A Power Rated power On Mode: 45 W (Typ.) Power consumption Sleep Mode: ≤ 0.5 W Off Mode: ≤ 0.5 W 729.4 mm x 428.9 mm x 55.5 mm / 5.2 kg Dimensions (Width Head...
  • Page 36 43SE3D 0.4902 mm (H) X 0.4902 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 0.9 A Power Rated power On Mode: 55 W (Typ.) Power consumption Sleep Mode: ≤ 0.5 W Off Mode: ≤ 0.5 W 969.6 mm x 563.9 mm x 38.6 mm / 9.6 kg Dimensions (Width Head x Height x Depth) /...
  • Page 37 49SE3D 0.55926 mm (H) X 0.55926 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 1.0 A Power Rated power On Mode: 60 W (Typ.) Power consumption Sleep Mode: ≤ 0.5 W Off Mode: ≤ 0.5 W 1102.2 mm x 638.5 mm x 38.6 mm / 13.9 kg Dimensions (Width Head x Height x Depth) /...
  • Page 38 1238 mm x 714.9 mm x 67.9 mm / 17.6 kg Head + Speaker 1238 mm x 773.4 mm x 219.6 mm / 19.9 kg Head + Speaker + Stand 55SE3KD 0.630 mm (H) x 0.630 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 1.1 A...
  • Page 39 65SE3D 0.744 mm (H) x 0.744 mm (V) LCD screen Pixel pitch AC 100-240 V~ 50/60 Hz 1.4 A Power Rated power On Mode: 90 W (Typ.) Power consumption Sleep Mode: ≤ 0.5 W Off Mode: ≤ 0.5 W 1456.9 mm x 838 mm x 41.1 mm / 27.7 kg Dimensions (Width Head x Height x Depth) /...
  • Page 40 RGB (PC) Support Mode Resolution Horizontal frequency (kHz) Vertical frequency (Hz) 720 x 400 31.468 70.8 640 x 480 31.469 59.94 800 x 600 37.879 60.317 1024 x 768 48.363 60.0 1280 x 720 44.772 59.855 1280 x 960 1152 x 864 57.717 59.934 63.981...
  • Page 41 HDMI (DTV) Support Mode Horizontal frequency Resolution Vertical frequency (Hz) (kHz) 480/60p 31.5 576/50p 31.25 720/50p 37.5 720/60p 1080/50i 28.1 33.75 1080/60i 1080/50p 56.25 1080/60p 67.5 NOTE • Resolutions available for the Input Label option in RGB, HDMI/ DVI-D input modes. - PC resolutions: 640 x 480 / 60 Hz, 1280 x 720 / 60 Hz, 1920 x 1080 / 60 Hz - DTV resolutions: 480p, 720p, 1080p •...
  • Page 42 ENERGY STAR® is a set of power-saving guidelines issued by the U.S.Environmental Protection Agency (EPA). Make sure to read the Safety Precautions before using the As an ENERGY STAR® Partner LGE U. S. A., product. Inc. has determined that this product The model and serial numbers of the SET are located on the meets the ENERGY STAR®...

Table of Contents