Toshiba TLP-X10U Owner's Manual page 61

FULL MENU settings – Audio (continued)
Control panel
Remote control
(Main unit side)
AUTO AUTO
KEYSTONE SET
INPUT ON/STANDBY
LASER
AUTO
KEYSTONE SET VOL/ADJ.
L-CLICK R-CLICK
4
VOLUME/ADJUST
ENTER EXIT
MENU INPUT
5
MENU ENTER EXIT
ON/STANDBY
PIP FREEZE
RESIZE
CALL MUTE
TEMP LAMP
BUSY FAN
4
4
5
5
Notes
ON
• If the power is turned off by pressing the ON/STANDBY button, the adjustments or settings
made are automatically stored in the memory. If the power cord is unplugged or if a power
failure occurs while the projector is on, the adjustments or settings are not stored in the
memory.
• The "Audio" settings are applied to all the input sources. (It is impossible to change the
settings for each input source.)
• The settings do no affect on the audio output signals from the AUDIO OUT jack.
• If either the memory card input or the document imaging camera input mode (for models with
document imaging camera) is selected, the sound is not developed.
Press VOL/ADJ (+/-) to adjust and set.
Speaker output
When set to "Off", no sound is produced from the speakers.
Channel select
L+R: The sound of the left and right channels is mixed and
developed from the speakers.
L: To develop only left input audio signal from the speakers.
R: To develop only right input audio signal from the speakers.
Loudness
When set to "On", the loudness effect is added to the speaker
sound.
After the settings are finished, press EXIT.
EXIT
The menu screen disappears.
EXIT
61
CONTENTS